Manual
33 DeepMind 6 User Manual
8. At this point move the PITCH WHEEL within the dead zone where you don't
feel the tension of the spring. This is ensure that no pitch information is sent
while the pitch wheel is not being touched. You will see the following display
showing a guide to assist you:
Note: To cancel the routine you can press the -/NO switch.
9. To conrm the CALIBRATION of the PITCH CENTRE press the +/YES switch:
The calibration data will then be stored for the PITCH CENTRE and you will
be returned to the CALIBRATE menu. From here you can perform another
calibration from the menu, or press the GLOBAL switch again to return to the
SYSTEM SETTINGS menu.
CAL AFTERTOUCH
To calibrate the KEYBOARD AFTERTOUCH, please use the following procedure:
Note: During the calibration the GLOBAL, -/NO and +/YES switches will be
ashing. If at any time you want to cancel the calibration routine, you can press
the -/NO switch. No previous calibration data will be changed if you do cancel the
routine. To conrm the calibration at each stage press +/YES as described below.
1. In order to start the calibration routine, make sure that the '<' symbol on the
CAL AFTERTOUCH line is highlighted and press +/YES.
2. You will see the following display showing a bar representing the current
AFTERTOUCH value (0% for no pressure). Also on this screen you can see the
stored calibration data above the bar and the current value below the bar:
3. Now apply pressure to any one of the keys (or multiple keys) until the value
stops increasing.
4. You will see the following display showing the maximum position of the
AFTERTOUCH and the associated value:
Note: To cancel the routine you can press the -/NO switch.
5. To conrm the CALIBRATION of the AFTERTOUCH press the +/YES switch:
The calibration data will then be stored for the AFTERTOUCH and you will
be returned to the CALIBRATE menu. From here you can perform another
calibration from the menu, or press the GLOBAL switch again to return to the
SYSTEM SETTINGS menu.