Calibration
Synthesizers and Samplers
DEEPMIND 6
page 8 of 9page 8 of 9
To calibrate the PEDAL please use the following process:
NOTE: During the calibration the GLOBAL, -/NO and +/YES switches will be ashing. If at any time you want to cancel the
calibration routine, you can press the -/NO switch. No previous calibration data will be changed if you do cancel the routine. To
conrm the calibration at each stage press +/YES as described below.
CALIBRATE PEDAL
In order to start the calibration routine, make sure that the '<' symbol on the CALIBRATE PEDAL line is highlighted
and press +/YES.
You will see the following display showing a bar representing the current PEDAL value (0% for no pressure).
Also on this screen you can see the stored calibration data above the bar and the current value below the bar:
Then press the pedal until the value stops increasing.
You will see the following display showing the maximum position of the PEDAL input and the associated value: