Calibration
Synthesizers and Samplers
DEEPMIND 6
page 6 of 9page 6 of 9
You will see the following display showing the maximum position of the PITCH WHEEL and the associated values:
To conrm the CALIBRATION of the PITCH WHEEL press the +/YES switch and you will be moved on to
the PITCH CENTRE page:
At this point move the PITCH WHEEL within the dead zone where you don't feel the tension of the spring. This is ensure
that no pitch information is sent while the pitch wheel is not being touched. You will see the following display showing
a guide to assist you:
NOTE: To cancel the routine you can press the -/NO switch.
To conrm the CALIBRATION of the PITCH CENTRE press the +/YES switch: The calibration data will then be stored for
the PITCH CENTRE and you will be returned to the CALIBRATE menu. From here you can perform another calibration
from the menu, or press the GLOBAL switch again to return to the SYSTEM SETTINGS menu.