Calibration

Synthesizers and Samplers
DEEPMIND 6
page 5 of 9page 5 of 9
To calibrate the PITCH WHEEL, please use the following procedure:
CAL PITCH WHEEL
You will see the following display showing a bar representing the PITCH WHEEL value. Also on this screen you can see
the stored calibration data above the bar and the current value below the bar:
In order to start the calibration routine make sure that the '<' symbol on the CAL PITCH WHEEL line is highlighted
and press +/YES.
Then move the PITCH WHEEL to its maximum position (shown on the panel).
You will see the following display showing the maximum position of the PITCH WHEEL and the associated values:
Then move the PITCH WHEEL to its minimum position (shown on the panel).