Calibration
Synthesizers and Samplers
DEEPMIND 6
page 4 of 9page 4 of 9
You will see the following display showing a bar representing the MOD WHEEL value. Also on this screen you can see
the stored calibration data above the bar and the current value below the bar.
Then move the MOD WHEEL to its maximum position (shown on the panel).
You will see the following display showing the new position of the MOD WHEEL and the associated values:
NOTE: To cancel the routine you can press the -/NO switch.
To conrm the CALIBRATION of the MOD WHEEL, press the +/YES switch: The calibration data will then be stored for the
MOD-WHEEL and you will be returned to the CALIBRATE menu. From here you can perform another calibration from
the menu, or press the GLOBAL switch again to return to the SYSTEM SETTINGS menu