Calibration
Synthesizers and Samplers
DEEPMIND 6
page 3 of 9page 3 of 9
The calibration routine will then start. Throughout the tests you will see various waveforms being played. It is safe to
turn down the volume while the calibration routine is running.
NOTE: While the calibration is running, you can mute the signal using the BANK/DOWN switch and un-mute using
the BANK/UP switch.
In order to start the calibration routine make sure that the '<' symbol on the CAL MOD WHEEL line is highlighted and
press +/YES.
In order to start the calibration routine, make sure that the '<' symbol is on the appropriate CALIBRATE line and
highlighted, and press the +/YES switch.
NOTE: The calibration run time is shown on the bottom of the screen so that you can plan your work around any of the
calibration phases.
First move the MOD WHEEL to its minimum position (shown on the panel).
To start the calibration routine, please follow the procedure below:
To calibrate the MOD WHEEL, please use the following procedure:
NOTE: During the calibration the GLOBAL, -/NO and +/YES switches will be ashing. If at any time you want to cancel the
calibration routine, you can press the -/NO switch. No previous calibration data will be changed if you do cancel the routine.
To conrm the calibration at each stage press +/YES as described below.
When the calibration routine is complete, you will see a summary of the test results as shown below. The 1st column is
Voice 1, 2nd is Voice 2, and so on:
NOTE: During the calibration, the GLOBAL and -/NO switches will be ashing. If at any time you want to cancel the
calibration routine, you can press the -/NO switch. No previous calibration data will be changed if you cancel
the routine.
CAL MOD WHEEL