Calibration
Synthesizers and Samplers
DEEPMIND 12
page 4 of 9page 4 of 9
You will see the following display showing a bar representing the MOD WHEEL value. Also on this screen you can see
the stored calibration data above the bar and the current value below the bar.
Then move the MOD WHEEL to its maximum position (shown on the panel).
Repeat steps 3 and 4 until both frequencies are correct A1 - 55 Hz and A4 - 440 Hz.
NOTE: To cancel the routine you can press the -/NO switch.
To conrm the CALIBRATION of the MOD WHEEL, press the +/YES switch: The calibration data will then be stored for the
MOD-WHEEL and you will be returned to the CALIBRATE menu. From here you can perform another calibration from
the menu, or press the GLOBAL switch again to return to the SYSTEM SETTINGS menu.