Manual

DIGITAL PRO MIXER DDM4000
Installation24
Setting the MIDI channel7.2.1
The following describe how to specify the MIDI channel on which
the DDM4000 is to send controller data. The receiving device
needs to be set to the same channel.
Open MIDI Setup (see Chapter 7.2).1)
Turn the left PARAMETER knob 2) [45] to select the MIDI
channel.
Press the ESC push button 3) [52] to exit MIDI Setup.
Sending a MIDI dump7.2.2
A MIDI dump sends the values of current controller positions. As
a result, the DDM4000’s settings are aligned with the connected
computer.
Open MIDI Setup (see Chapter 7.2).1)
Press the left PARAMETER knob 2) [45] to start the MIDI
dump. After sending the dump, the DDM4000 returns to
MIDI Setup.
Press the ESC push button 3) [52] to exit MIDI Setup.
Conguring Microphone channel, Sampler 7.3
and crossfader as MIDI controller
The Microphone channel, the Sampler and the crossfader section
can individually be converted to MIDI controllers.
Open MIDI Setup (see Chapter 7.2).1)
Turn the CONSOLE SETUP knob 2) [51] to select the mixer
section (MIC, SAMPLER, CROSSFADER) you want to use.
Press the CONSOLE SETUP knob to conrm the selection. 3)
The LEDs of the selected section go out.
Press the ESC push button 4) [52] to exit MIDI Setup.
Particularities of the crossfader:
It is not possible to assign the stereo channels to the crossfader
when the crossfader section is dened as controller. The Assign
push buttons are inoperative. The routing behaves as if the cross-
fader is deactivated: the signals are directly fed to the mixer’s sum.
As for the Sampler, the CF Assign function and CF Start function
are also inoperative. As usual, the routing of the Sampler signal
is realized with the REC SOURCE push button.
Conguring stereo channels as 7.4
MIDI controller
Using the channel fader {8}, the EQ knobs {4} and the kill push
buttons {5} and {6} generates MIDI data when one of the 4 stereo
channels is congured as MIDI controller. The congured channel
is still able to play back music, however, the equalizer, the channel
fader and the CF Assign function are not active. In case an audio
signal is being fed to the selected channel, it is routed to the mixer’s
sum without being processed and at full volume level. Simply mute
the signal in case the audio function is not required.
Open MIDI Setup (see Chapter 7.2).1)
Turn the right PARAMETER knob 2) [45] to select the stereo
channel you want (and, if required, the Mute function).
Press the PARAMETER knob to conrm the selection. The 3)
push-button LEDs of the selected channel go out.
Press the ESC push button + [52] to exit MIDI Setup. Level
jumps can occur when activating or deactivating the
MIDI controller function in a stereo channel depending
on the position of the equalizer and fader! Turn the OUT-
PUT knob in the Main and Phones section completely
to the left before activating this function.
Installation8.
The inputs and outputs of the BEHRINGER DDM4000 are RCA
connectors. The Headphone output is a stereo jack. The Micro-
phone inputs are XLR connectors.
Make sure that only competent people install your +
DDM4000. They must be sufciently earthed during and
after the installation process. Otherwise, electrostatic
discharges may negatively affect the operating charac-
teristics of your equipment.
XLR connectorFig. 8.1:
1/4" headphones connectorFig. 8.2:
RCA cableFig. 8.3: