User Manual

11 SHARK FBQ100 User Manual
Specications4.
Audio Inputs
Connectors XLR and ¼" TRS jack
Impedance 6 kΩ balanced, 3 kΩ unbalanced
Nominal operating level Microphone or line level source (switchable)
Max. input level +19 dBu at microphone level and line level
Audio Outputs
Connectors XLR and ¼" jack
Impedance 60 Ω balanced, 30 Ω unbalanced
Nominal operating level Microphone level source or +4 dBu (switchable)
Max. output level +20 dBu at +4 dBu nominal level,
-12 dBu at microphone level
System Specications
Frequency response 10 Hz to 21 kHz
Noise > 92 dB at line level, unweighted,
22 Hz to 22 kHz
> 89 dB at microphone level, unweighted,
22 Hz to 22 kHz
THD 0.007% typ. @ +4 dBu, 1 kHz, gain 1
Digital Processing
Converters 24-bit Sigma-Delta, 64/128-times oversampling
Display
Type 4-digit numeric LED display
Power Supply
Mains Voltages/Power Consumption
USA/Canada 120 V~ 60 Hz 19 W
U.K./Australia 240 V~ 50 Hz 20.5 W
Europe 230 V~ 50 Hz 20 W
Korea 220 V~ 50 Hz 20 W
China 220 V~ 50 Hz 20 W
Japan 100 V~ 50/60 Hz 18 W
Physical
Dimensions (H x W x D) approx. 2.2 x 3.5 x 5.2" / 56 x 88 x 132 mm
Net Weight approx. 0.84 lbs / 0.38 kg
BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts,
modifications may be made from time to time to existing products without prior notice. Specifications and
appearance may differ from those listed or illustrated.
Rackmount (Optional)5.
With the available rackmount (optional) you have the possibility to place ve
SHARKs on two units of space in your rack.
Before you begin with the work, please disconnect the Power Supply ◊
Units from the SHARKs!
To mount the SHARKs on the rackmount you should use the supplied screws (type
M3). You need two screws to x one FBQ100 onto the rackmount. In the bottom
of your SHARK you will nd two little threads. You have to position the single
SHARKs on the rackmount, so that the threads correspond to the cutouts of the
rackmount (see g. 5.1). Now you can x the FBQ100 onto the rackmount. Just
take a cross-point screwdriver and tighten both screws loosely. After you have
xed all SHARKs on the rackmount, you can adjust the devices and tighten all
screws solidly.
Bottom FBQ100
Thread 1
Cutout 1
Cutout 2
Front Rackmount (Bottom View)
Thread 2
Fig. 5.1: Installation of the FBQ100 on the available rackmount (optional)
Please, only use the supplied screws to install the SHARKs on the ◊
rackmount. Longer or thicker screws can damage the electronics inside
of the device and doing so will void your warranty rights.
You will need 2 units of space for the FBQ100 rackmount. For technical reasons a
little gap remains above the rackmount.