SDS

ManualsBrandsBEHR ManualsCaulk & SealantsTotal Flex 10.1 fl. oz. White Elastomeric Window & Door Sealant

SAFETY DATA SHEET

1. Identification

BEHR Total Flex, White

Product identifier

Other means of identification

BS30

Product number

Sealant.

Recommended use

None known.

Recommended restrictions

Manufacturer/Importer/Supplier/Distributor information

Supplier

Telephone

Emergency telephone

Access code

2. Hazard(s) identification

Physical hazards

Category 2

Health hazards

Category 2A

Behr Process Corp.

1801 E. St. Andrew Place

Santa Ana, CA 92705

714-545-7101

+1 760 476 3962

+1 866 519 4752

335213

Not classified.

Skin corrosion/irritation

Serious eye damage/eye irritation

Category 3 respiratory tract irritationSpecific target organ toxicity, single exposure

Category 1 (central nervous system)Specific target organ toxicity, repeated

exposure

Not classified.

OSHA defined hazards

Label elements

Signal word

Danger

Hazard statement

Causes skin irritation. Causes serious eye irritation. May cause respiratory irritation. Causes

damage to organs (central nervous system) through prolonged or repeated exposure.

Precautionary statement

Prevention

Do not breathe mist/vapors. Wash thoroughly after handling. Do not eat, drink or smoke when

using this product. Use only outdoors or in a well-ventilated area. Wear protective gloves/eye

protection/face protection.

Response

If on skin: Wash with plenty of water. If skin irritation occurs: Get medical advice/attention. Take

off contaminated clothing and wash it before reuse. If in eyes: Rinse cautiously with water for

several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye

irritation persists: Get medical advice/attention. If inhaled: Remove person to fresh air and keep

comfortable for breathing. Call a poison center/doctor if you feel unwell.

Storage

Store in a well-ventilated place. Keep container tightly closed. Store locked up.

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulations.

Hazard(s) not otherwise

classified (HNOC)

None known.

Supplemental information

None.

3. Composition/information on ingredients

Mixtures

BEHR Total Flex, White

SDS US

Version #: 01 Revision date: - Issue date: 14-April-2021

1 / 8

Summary of content (8 pages)

PAGE 1
SAFETY DATA SHEET 1. Identification Product identifier BEHR Total Flex, White Other means of identification Product number BS30 Recommended use Sealant. Recommended restrictions None known. Manufacturer/Importer/Supplier/Distributor information Behr Process Corp. Supplier 1801 E. St. Andrew Place Santa Ana, CA 92705 714-545-7101 Telephone +1 760 476 3962 Emergency telephone +1 866 519 4752 335213 Access code 2. Hazard(s) identification Physical hazards Not classified.
PAGE 2
Chemical name CAS number % Limestone 1317-65-3 35 - 45 Proprietary acrylic polymer mixture Proprietary 20 - 40 Distillates (petroleum), hydrotreated light 64742-47-8 1-3 Titanium dioxide 13463-67-7 1-3 Quartz (SiO2) 14808-60-7 0 - 0.4 Composition comments All concentrations are in percent by weight unless ingredient is a gas. Gas concentrations are in percent by volume. The manufacturer has claimed the exact percentage as trade secret under the OSHA Hazard Communication Standard. 4.
PAGE 3
Methods and materials for containment and cleaning up Prevent entry into waterways, sewer, basements or confined areas. Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.
PAGE 4
Biological limit values No biological exposure limits noted for the ingredient(s). Appropriate engineering controls Good general ventilation should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Provide eyewash station and safety shower.
PAGE 5
10. Stability and reactivity Reactivity The product is stable and non-reactive under normal conditions of use, storage and transport. Chemical stability Material is stable under normal conditions. Possibility of hazardous reactions No dangerous reaction known under conditions of normal use. Conditions to avoid Heat, flames and sparks. Protect against direct sunlight. Contact with incompatible materials. Incompatible materials Strong oxidizing agents.
PAGE 6
Aspiration hazard Not an aspiration hazard. Chronic effects Prolonged inhalation may be harmful. Causes damage to organs through prolonged or repeated exposure. 12. Ecological information Ecotoxicity The product is not classified as environmentally hazardous. Persistence and degradability No data is available on the degradability of any ingredients in the mixture. Bioaccumulative potential No data available. Mobility in soil No data available.
PAGE 7
Classified hazard categories Skin corrosion or irritation Serious eye damage or eye irritation Specific target organ toxicity (single or repeated exposure) SARA 313 (TRI reporting) Not regulated. Other federal regulations Clean Air Act (CAA) Section 112 Hazardous Air Pollutants (HAPs) List Not regulated. Clean Air Act (CAA) Section 112(r) Accidental Release Prevention (40 CFR 68.130) Not regulated. Contains component(s) regulated under the Safe Drinking Water Act.
PAGE 8
Disclaimer BEHR Total Flex, White Version #: 01 Masterchem Industries LLC cannot anticipate all conditions under which this information and its product, or the products of other manufacturers in combination with its product, may be used. It is the user’s responsibility to ensure safe conditions for handling, storage and disposal of the product, and to assume liability for loss, injury, damage or expense due to improper use.