SDS

ManualsBrandsBEHR ManualsGeneral Purpose Spray Paint12 oz. Clear Flat Interior/Exterior Spray Paint and Primer in One Aerosol

SAFETY DATA SHEET

1. Identification

Behr Aerosol Paint + Primer - Clear FlatProduct identifier

Other means of identification

B002344

Product code

Architectural Coating

Recommended use

None known.

Recommended restrictions

Manufacturer/Importer/Supplier/Distributor information

Behr Process Corp.

Supplier

1801 E. St. Andrew Place

Santa Ana, CA 92705

714-545-7101

Telephone

(800)-424-9300 CHEMTREC®

Emergency telephone

number

2. Hazard(s) identification

Category 1Flammable aerosols

Physical hazards

Compressed gasGases under pressure

Category 2ASerious eye damage/eye irritation

Health hazards

Category 3 respiratory tract irritationSpecific target organ toxicity, single exposure

Category 3 narcotic effectsSpecific target organ toxicity, single exposure

Not classified.

OSHA defined hazards

Label elements

Signal word

Danger

Hazard statement

Extremely flammable aerosol. Contains gas under pressure; may explode if heated. Causes

serious eye irritation. May cause respiratory irritation. May cause drowsiness or dizziness.

Precautionary statement

Prevention

Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open

flame or other ignition source. Pressurized container: Do not pierce or burn, even after use. Avoid

breathing mist/vapor. Wash thoroughly after handling. Use only outdoors or in a well-ventilated

area. Wear eye protection/face protection.

Response

If inhaled: Remove person to fresh air and keep comfortable for breathing. If in eyes: Rinse

cautiously with water for several minutes. Remove contact lenses, if present and easy to do.

Continue rinsing. Call a poison center/doctor if you feel unwell. If eye irritation persists: Get

medical advice/attention.

Storage

Store in a well-ventilated place. Keep container tightly closed. Store locked up. Protect from

sunlight. Do not expose to temperatures exceeding 50°C/122°F.

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulations.

Hazard(s) not otherwise

classified (HNOC)

None known.

Supplemental information

None.

3. Composition/information on ingredients

Mixtures

67-64-1 20 - 40Acetone

CAS number %Chemical name

Behr Aerosol Paint + Primer - Clear Flat SDS US

-946329 Version #: 1.0 Revision date: 8-9-19 Issue date: 8-9-19

1 / 9

Summary of content (9 pages)

PAGE 1
SAFETY DATA SHEET 1. Identification Product identifier Behr Aerosol Paint + Primer - Clear Flat Other means of identification Product code B002344 Recommended use Architectural Coating Recommended restrictions None known. Manufacturer/Importer/Supplier/Distributor information Supplier Telephone Emergency telephone number Behr Process Corp. 1801 E. St. Andrew Place Santa Ana, CA 92705 714-545-7101 (800)-424-9300 CHEMTREC® 2.
PAGE 2
Isobutyl acetate 110-19-0 10 - 20 Methyl ethyl ketone 78-93-3 10 - 20 Propane 74-98-6 10 - 20 Isobutane 75-28-5 2.5 - 10 2-Methoxy-1-methylethyl acetate 108-65-6 2.5 - 10 Composition comments The manufacturer has claimed the exact percentage as trade secret under the OSHA Hazard Communication Standard. 4.
PAGE 3
7. Handling and storage Precautions for safe handling Conditions for safe storage, including any incompatibilities Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Pressurized container: Do not pierce or burn, even after use. Do not use if spray button is missing or defective. Do not spray on a naked flame or any other incandescent material. Do not smoke while using or until sprayed surface is thoroughly dry.
PAGE 4
US. NIOSH: Pocket Guide to Chemical Hazards Components Type Value 1000 ppm US. Workplace Environmental Exposure Level (WEEL) Guides Components Type 2-Methoxy-1-methylethyl acetate (CAS 108-65-6) TWA Biological limit values ACGIH Biological Exposure Indices Components Value Acetone (CAS 67-64-1) Value 25 mg/l 50 ppm Determinant Specimen Acetone Urine * Urine * Methyl ethyl ketone (CAS 2 mg/l MEK 78-93-3) * - For sampling details, please see the source document.
PAGE 5
Upper/lower flammability or explosive limits 2.2 % estimated Flammability limit - lower (%) Flammability limit - upper (%) 11.5 % estimated Vapor pressure 55 - 65 psig at 20°C estimated 108 - 128 psig at 54 °C estimated Vapor density Not available. Relative density 0.766 estimated Solubility(ies) Solubility (water) Not available. Partition coefficient (n-octanol/water) Not available. Auto-ignition temperature Not available. Decomposition temperature Not available. Viscosity Not available.
PAGE 6
Components Species Test Results Dermal LD50 Rabbit > 15700 mg/kg, 24 Hours Inhalation Vapor LC50 Rat 76 mg/l, 4 Hours Oral LD50 Rat 5800 mg/kg Mouse 52 mg/l, 1 Hours Dermal LD50 Rabbit > 5000 mg/kg Oral LD50 Rat 13400 mg/kg Dermal LD50 Rat 6400 mg/kg Inhalation Vapor LC50 Rat 34.
PAGE 7
Specific target organ toxicity repeated exposure Not classified. Aspiration hazard Not an aspiration hazard. Chronic effects Prolonged inhalation may be harmful. 12. Ecological information Ecotoxicity The product is not classified as environmentally hazardous. Persistence and degradability No data is available on the degradability of any ingredients in the mixture. Bioaccumulative potential Partition coefficient n-octanol / water (log Kow) Isobutyl acetate (CAS 110-19-0) No data available.
PAGE 8
Transport hazard class(es) Class Subsidiary risk Packing group Environmental hazards Marine pollutant EmS Special precautions for user Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code 2.1 No F-D, S-U Read safety instructions, SDS and emergency procedures before handling. Not applicable. 15. Regulatory information US federal regulations This product is a "Hazardous Chemical" as defined by the OSHA Hazard Communication Standard, 29 CFR 1910.1200.
PAGE 9
Methyl ethyl ketone (CAS 78-93-3) 6714 FEMA Priority Substances Respiratory Health and Safety in the Flavor Manufacturing Workplace Acetone (CAS 67-64-1) Low priority Isobutyl acetate (CAS 110-19-0) Low priority Methyl ethyl ketone (CAS 78-93-3) Low priority US state regulations US. Massachusetts RTK - Substance List Acetone (CAS 67-64-1) Isobutane (CAS 75-28-5) Isobutyl acetate (CAS 110-19-0) Methyl ethyl ketone (CAS 78-93-3) Propane (CAS 74-98-6) US.