TDS
Revised 6/2014
TECHNICAL DATA SHEET
Revised 4/2019
This information is provided "as is" and no representations or warranties, either expressed or implied, of merchantability, tness for a particular purpose or of any other
nature are made with respect to this information or to any product referred to in this information. For SDS or to consult with a Behr Certied Coatings Professional,
call 1-800-854-0133 Ext. 2 (U.S.A. only). ©2019 Behr Process Corporation, Santa Ana, CA 92705 U.S.A.
IMPORTANT NOTE: While BEHR Interior/Exterior Bonding
Primer is formulated to bond without sanding, it is
recommended that a small area be tested for adhesion prior
to beginning the job.
BEHR Interior/Exterior Bonding Primer is not designed to
reattach loose, aking or peeling paint. Such conditions
must be corrected prior to applying this primer.
Applying BEHR Interior/Exterior Bonding Primer to glass will
block out light. Dark colors absorb more heat than lighter
colors. This added heat causes thermal stress which may
aect the glass and can cause it to break.
Due to the diverse composition of plastic substrates, always
test a small area for acceptable adhesion. Many types
of highly engineered plastics present a challenge with
adhesion. Please contact your Behr representative for proper
recommendations.
Do not use solvents that contain hydrocarbon such as
mineral spirits because they can leave an oily residue. Use a
water-based cleaner/degreaser for cleaning the surface.
WARNING! If you scrape, sand or remove old paint, you may
release lead dust. LEAD IS TOXIC. Contact the National Lead
Information Center at 1-800-424-LEAD or visit www.epa.
gov/lead.
CLEAN UP:
Clean all tools and equipment with clean water. For disposal
of empty containers, unused paint and soiled rags, contact
your household refuse collection service.
CAUTIONS/LIMITATIONS:
• Protect from freezing.
• Do not use on oors.
• Do not use when air and surface temperatures are below
50°F or above 90°F.
• Topcoat within 14 days.
• Shelf life under normal conditions is two years unopened.
2 of 2
INTERIOR/EXTERIOR BONDING PRIMER
NO. 432
GENERAL INFORMATION:
WARNING IRRITANT HARMFUL IF SWALLOWED.
AVOID CONTACT WITH EYES. MAY CAUSE EYE, NOSE AND
THROAT IRRITATION. AVOID BREATHING OF DUST, VAPORS
OR SPRAY MIST. USE ONLY WITH ADEQUATE VENTILATION.
Open windows and doors or use other means to ensure fresh
air entry during application and drying. If you experience
eye watering, headache or dizziness or if air monitoring
demonstrates vapor / mist levels are above applicable limits,
wear an appropriate, properly tted respirator (NIOSH /
MSHA TC-23C or equivalent) during and after application.
Follow respirator manufacturer’s direction for respirator
use. Close container after each use. Wash thoroughly after
handling and before smoking and eating. FIRST AID: If
swallowed, do not induce vomiting. Get medical attention
immediately. If you experience diculty in breathing,
leave the area to obtain fresh air. If continued diculty is
experienced, get medical attention immediately. In case of
eye contact, ush eyes immediately with plenty of water for
at least 20 minutes and get medical attention.
CAUTION: KEEP OUT OF REACH OF CHILDREN –
DO NOT TAKE INTERNALLY.