SAFETY DATA SHEET SECTION 1 : IDENTIFICATION Product Name: BEHR Bonding Primer No. 432 Product Code: 432 SDS Manufacturer Number: 432 Manufacturer Name: Behr Paint Company Address: 1801 E. St. Andrew Place Santa Ana, CA 92705 General Phone Number: (714) 545-7101 General Fax Number: (714) 545-7101 Customer Service Phone Number: (800) 854-0133 ext.
Precautionary Statements: Wear protective clothing, gloves, eye, and face protection. Do not eat, drink or smoke when using this product. Wash hands thoroughly after handling. Take off contaminated clothing and wash it before reuse. Dispose of unused contents, container, and other contaminated wastes in accordance with local, state, federal, and provincial regulations. If in eyes: Rinse cautiously with water for several minutes and remove contacts if present and easy to do.
SECTION 4 : FIRST AID MEASURES Eye Contact: Immediately flush eyes with plenty of water for at least 15 to 20 minutes. Ensure adequate flushing of the eyes by separating the eyelids with fingers. Remove contacts if present and easy to do. Continue rinsing. Get medical attention, if irritation or symptoms of overexposure persists. Skin Contact: Immediately wash skin with soap and plenty of water. Get medical attention if irritation develops or persists. Inhalation: If inhaled, remove to fresh air.
Methods for cleanup: Clean up spills immediately observing precautions in the protective equipment section. Place into a suitable container for disposal. Provide ventilation. After removal, flush spill area with soap and water to remove trace residue. SECTION 7 : HANDLING and STORAGE Handling: Use with adequate ventilation. Avoid breathing vapor and contact with eyes, skin and clothing.
Guideline ACGIH: Skin: Yes. TLV-STEL: 150 ppm TLV-TWA: 100 ppm Guideline OSHA: PEL-TWA: 100 ppm PEL-STEL: 150 ppm Skin: Yes. Titanium dioxide : Guideline ACGIH: TLV-TWA: 10 mg/m3 Talc, Magnesium silicate hydrate : Guideline ACGIH: TLV-TWA: 1 mg/m3 Respirable fraction (R) Guideline OSHA: PEL-TWA: 20 mppcf SECTION 9 : PHYSICAL and CHEMICAL PROPERTIES Physical State: Liquid. Color: White Odor: Slight. Odor Threshold: Not applicable.
SECTION 11 : TOXICOLOGICAL INFORMATION Dipropylene glycol monomethyl ether : Eye: Administration into the eye - Rabbit Standard Draize test: 500 mg/24H [Mild] (RTECS) Skin: Administration onto the skin - Rabbit LD50 - Lethal dose, 50 percent kill: 10 mL/kg [Details of toxic effects not reported other than lethal dose value] (RTECS) Ingestion: Oral - Rat LD50 - Lethal dose, 50 percent kill: 5400 uL/kg [Details of toxic effects not reported other than lethal dose value] Oral - Rat LD50 - Lethal dose, 50
DOT Shipping Name: Not restricted as a dangerous good. DOT UN Number: Not restricted as a dangerous good. IATA Shipping Name: Not restricted as a dangerous good. IATA UN Number: Not restricted as a dangerous good. Canadian Shipping Name: Not restricted as a dangerous good. Canadian UN Number: Not restricted as a dangerous good. IMDG UN Number : Not restricted as a dangerous good. IMDG Shipping Name : Not restricted as a dangerous good. ADR UN Number: Not restricted as a dangerous good.
SECTION 16 : ADDITIONAL INFORMATION HMIS Ratings: HMIS Health Hazard: 1 HMIS Fire Hazard: 1 HMIS Reactivity: 0 SDS Creation Date: April 12, 2019 SDS Revision Date: April 12, 2019 SDS Format: In accordance with 2012 OSHA Hazardous Communication Standard SDS Author: Actio Corporation Disclaimer: This Health and Safety Information is correct to the best of our knowledge and belief at the date of its publication but we cannot accept liability for any loss, injury or damage which may result from