Data Sheet
Table Of Contents
- Coverpage - Module Uni v1.1
- blank after front cover
- MYTHINGS Module Uni Rapid Prototyping Datasheet v1.1 no covers
- Datasheet
- Overview
- Product Features
- Functional Block Diagram
- Environmental Conditions
- Electronic Characteristics
- Pinout Diagram
- Flashing the Firmware
- Radio Specifications
- Antenna
- How to Connect to a MYTHINGS Network
- RF Exposure Requirements
- Safety Instructions
- Additional Notes and Information
- Regulatory Notes
- Statement for Modular Approval
- Obtaining Updates
- Related Documents
- Versions
- black before back cover
- Coverpage - Module Uni v1.1
MYTHINGS Rapid Prototyping Module Datasheet ©BehrTech 2020 5
Version 1.1
Note: the EUI information in the QR tag includes \r\n to indicate a new line. When adding a new
node into MYTHINGS Central, do not copy the \r\n as part of the EUI. Also, be aware that the QR
tag does not include the Node Type. You must add this separately.
RF Exposure Requirements
To comply with FCC RF exposure compliance requirements, the device must be installed to
provide a separation distance of at least 20 cm from all persons.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Safety Instructions
The MYTHINGS Module (uni) is a low power circuit board operating at 5V DC. The board is
equipped with a mikroBUS interface and connector and is designed to be used in combination
with an additional base board that is equipped with a mikroBUS host socket. This socket
provides power supply and data connectivity to interface directly with the module.
To connect and disconnect the module to the base board using the mikroBUS interface:
1. Disconnect the base board from power supply.
2. Connect the MYTHINGS Module (uni) via the mikroBUS interface.
3. Ensure the correct orientation of both boards.
4. Reconnect the power supply.
Additional Notes and Information
This radio transmitter 25059-MY-UNIMODNA has been approved by Innovation, Science and
Economic Development Canada to operate with the antenna types listed below, with the
maximum permissible gain indicated. Antenna types not included in this list that have a gain
greater than the maximum gain indicated for any type listed are strictly prohibited for use with this
device.
BehrTech provides a mikroSDK-compliant code library to help you build and compile your own
application on the MYTHINGS Rapid Prototyping Module. For more information, contact
support@behrtech.com.
You can learn more about MikroE starter boards and MikroE compilers.