Use and Care Manual

6 7
Setting up your Connected BrewerKnowing your Brewer (continued)
1. Remove all packing materials.
2. Check to ensure all parts and accessories are included and the brewer is not
damaged.
3. Wipe out reservoir and wash and rinse the removable components (filter basket,
gold filter, carafe, and lid) with mild dishwashing detergent.
4. Plug the Behmor Brewer into the power outlet.
5. Open the Behmor app and follow instruction to connect your new Brewer to
the app.
6. Once your Behmor Brewer is online and connected to the app go to Settings
(in the app)>Maintenance>Calibrate Brewer
7. Now follow the instructions to calibrate the brewer.
8. After calibration procedure is complete, emply reservoir and fill with cold water
to maximum line (1.2L/ 8 Cup) and place reservoir lid over reservoir.
9. Press “Start/Stop” to run a brewing cycle. This rinses the internal components
before the first use. Be sure carafe and other items are in proper place(s).
The control panel
Start/Stop Button: Use the Start/Stop button to begin a brewing cycle, stop a brewing
cycle, empty water from the reservoir (press and hold for 5 seconds), or reset to factory
settings (press and hold for 10 seconds).
DADO
TM
Button: The DADO light will inform you of the connection and functional status of
your Behmor Brewer. Here’s what the DADO button does:
OFF: Not connected to the Internet
ON/SOLID: Connected to the Internet
ON/BLINKING (ONCE PER SECOND): Either needs to be paired to the home Wi-Fi
network or (if that has already happened) you need to push the DADO button to try
and reconnect.
TIP: Hold down the Start/Stop button for 5 seconds to purge water from the reservoir.
Start/Stop