Owner manual

F-19666-1 Rev. 11-29-01 11-21-00
1. Install poly boards into the stall front and door (door not shown in illustration). See chart below for
reference guide.
2. Place Swing Out Door F/PHSW into the opening. At the same time, install board C. Mark the
locations of the four outside holes and then drill through the poly using a 7/16” dia. drill bit.
3. Place the Poly Reinforcement Backing Frame into place and bolt the backing frame to the
Swing-out Door Frame using the 3/8” x 2” bolts supplied in the hardware bag. (See illustration
below for reference).
12’ POLY BOARD CHART
Ref. Wood Size Stall - Qty. Door - Qty.
A 2” x 6” x 35½” 4 - - -
B 2” x 6” x 47½” 7 8
C 2”x6”x22” 1 ---
D 2” x 6” x 24¾” 4 - - -
E 2” x 2” x 35½” 2 - - -
F 2” x 2” x 47½” 1 1
G 1” x 2” x 35½” 1 - - -
H 1” x 2” x 47½” - - - 1
12’ Front Horse Stall
with poly boards
installed
Reinforcement
Backing Frame
Swing Out Door F/PHSW