User's Manual

Wireless Presenter Mouse
6
Hardware Installation
1. Plug the dongle receiver connector into your USB port on the PC. During the initial
installation, the system will automatically detect that a new hardware device has
been added and will bring up an installation dialogue box. Please follow the
on-screen instructions to complete the installation steps.
Front view of receiver
Back view of receiver
2. Check if the batteries of the presenter mouse are installed correctly, please follow
the polarity signs in the battery compartment.
3. Before using the presenter, please make sure the power slide switch on the left side is
switched to “on”. When not in use, please turn the power slide switch to “off” for
power saving.
4. The wireless presenter mouse can operate out of the box immediately after you first
plug the dongle receiver’s USB connector into your PC USB port. After you first plug the
receiver’s USB connector into your PC USB port, please hold the Presenter Mouse close
to the receiver within 1M and press any buttons to make sure it works, if not, please do
the pairing procedure.
Note:
- When the presenter mouse is not in use, the dongle receiver can be conveniently
stored in the receiver compartment on the back of the presenter mouse. See the
diagram below.
- The presenter mouse uses 2pcs standard UM-4 (AAA) 1.5V alkaline batteries.
- The battery life is up to 3 months; depending on the intensity of usage.