User Manual

2/2
4. Set up will indicate when installation has successfully completed. The driver is loaded when
you see the driver icon
on Windows system tray. The operating system needs to restart.
Battery Low Alarm
After installing the KeyMaestro Input Device Driver, computer will display a battery low icon
on the upper-right corner of your screen and flash for 10 seconds to indicate low batteries when the
batteries are low in the unit. After changing the batteries, please remember to set ID settings.
Important
1. This optical mouse uses light to sense movement. It cannot work on a glass, translucent or
reflective surface.
2. Use the mouse only on a clean, flat, non-slippery, opaque surface in order to ensure smooth
and accurate cursor action
3. You can adjust the double-click speed of mouse by opening up the Mouse Properties in the
Windows Control Panel and changing the speed.
FCC GUIDELINES
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and receiver

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Use only shielded cables to connect I/O devices to this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference. (2) This device must accept any interference received,
including interference that may cause undesired operation.
Information to User:

Any changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate this equipment. Shielded interface cable, if any, must be used in order to
comply with emission limits.
IBM AT and PS/2 are registered trademarks of International Business Machines Corporation.