User Manual

Important Information
1. This optical mouse uses light to sense movement. It cannot work on a glass, translucent
or reflective surface.
2. Use the mouse only on a clean, flat, non-slippery, opaque surface in order to ensure
smooth and accurate cursor action.
F
F
C
C
C
C
G
G
U
U
I
I
D
D
E
E
L
L
I
I
N
N
E
E
S
S
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
s Reorient or relocate the receiving antenna
s Increase the separation between the equipment and receiver
s Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
s Consult the dealer or an experienced radio/TV technician for help.
The Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulation.
Cet appareil numerique de la class B respecte toutes les exigences du Règlement sur le materiel brouilleur du Canada.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference. (2) This device must accept any interference received, including interference that may cause
undesired operation.
Information to User:
F Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment. Shielded interface cable, if any, must be used in
order to comply with emission limits.