User's Manual

7
Remarks:
1.
You must follow the procedure above to set the ID of receiver, and then keyboard.
Once the receiver ID button is pressed, you have 30 seconds to complete the
entire process, or you will need to begin again.
2.
If the keybaord does not work after ID setting procedure, or the signal transmission
between receiver and keybaord is interupted, please do proceed ID setting
procedure again.
3. Once the keyboard and receiver are plugged in, the yellow receiver light will flash.
Once the ID is set, it will remain steadily lit.
4. When changing the batteries of keyboard, please remember to reset the ID.
5. When keyboard batteries are low, a battery low icon
will show on the system
tray.