User Manual

3 Hardware Installation

Slide Switch Setting

Step 1: Make sure your PC is switched off.

Step 2: Take the receiver and select channel CH1 or CH2 by using the slide

switch on the back of the receiver. (Remember your selection.)

Step 3: Connect the receiver to your PC by plugging in the receiver’s PS/2

mouse connector into the mouse port of your PC and the PS/2 keyboard

connector into the keyboard port.

Mouse Connector Keyboard Connector

Step 4: Take the keyboard and make sure the batteries on the back are

installed correctly. (Follow the polarity signs in the battery compartment.)

Step 5: Use the slide switch on the back of the keyboard to select the same

Bottom View of Receiver

Slide Switch Setting

Bottom View of Keyboard

ID Button

Slide Switch

(+)

(-)

Battery 1.5V 2pcs