Product Specs

AP-02FP Blutooth LE Module Specification Ver0.4
April 20, 2020
10
7. RF Warnings
NCC statement:
取得審驗證明之低功率射頻器材，非經核准，公司、商號或使用者均不得擅自變更頻率、加大功率
或變更原設計之特性及功能。
低功率射頻器材之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並
改善至無干擾時方得繼續使用。
前述合法通信，指依電信管理法規定作業之無線電通信。
低功率射頻器材須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
此模組於取得認證後將依規定於模組本體標示審驗合格標籤，並要求平台廠商於平台上標示本產品
內含發射器模組
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter
ference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no gua
rantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turnin
g the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipme
nt should be installed and operated with a minimum distance of 20 cm between the radiator and a human body.
If theidentification number is not visible when the module is installed inside another device, then the outside
of the device into which the module is installed must also display a label referring to the enclosed module, Contains F
CC ID: XXXXXXXX, (XXXX should be corrected in accordance with current module ID).
Co‐location of this module with other transmitters that operate simultaneously are required to be evaluated using th
e multi‐transmitter procedures.
The host integrator must follow the integration instructions provided in this document and ensure that the
composite‐system end product complies with the requirements by a technical assessment or evaluation to the rules a
nd to KDB Publication 996369.
The host integrator installing this module into their product must ensure that the final composite product
complies with the requirements by a technical assessment or evaluation to the rules, including the
transmitter operation and should refer to guidance in KDB 996369.
