Manualshelf

User Manual

ManualsBrandsBeha-Amprobe ManualsElectrical & Electronic Test InstrumentsTelaris ProInstall-100 Installation Tester + 2100-Beta Voltage Tester, 1GOhm, ±5 %, IP40
11121314151617181920
7
25
Indicates the selected rotary switch setting. The measurement value in the
primary display also corresponds to the switch setting. Rotary switch settings are:
Insulation RCD trip time
Continuity RCD trip current
Loop no trip Earth
Loop hi current trip Phase Rotation
26
Indicates the preset fault voltage limit. The default setting is 50 V. Some
locations require the fault voltage be set to 25 V, as specified by local electrical
codes. Press F4 when you turn on the tester to toggle the fault voltage
between 25 V and 50 V. The value you set will appear on the display and will be
saved when you turn the tester off.
 Primary display and measurement units.
28
Memory locations. See page 37 for detailed information on using memory
locations.
29
Low battery icon. See “Testing and Replacing the Batteries” on page 41 for
additional information on batteries and power management.
30 Appears when you press the Recall button and you are looking at stored data.
31 Appears when you press the Memory button.
32
Appears when you press the Test button. Disappears when the test is
completed.
33
Appears when the instrument is overheated. The Loop test and RCD functions
are inhibited when the instrument is overheated.
34
Appears when an error occurs. Testing is disabled. See “Error Codes” on page
16 for a listing and explanation of possible error codes.
35 Appears when the instrument is uploading data using Amprobe PC software.
36
Name of the secondary measurement function.
U
N
- Test voltage for insulation test.
U
F
- Fault voltage. Measures neutral to earth.
PSC - Prospective Short Circuit. Calculated from measured voltage and impedance

Secondary display and measurement units. Some tests will return more than
one result or return a computed value based on the test result. This will occur
with:
•Volts•RCDswitchingtime
•Insulationtests•RCDtrippingcurrent
•Loop/lineimpedance
38 Press F3 to compensate the test lead for the continuity function.
39 Appears when a compensation value for the test exists.
40 Potential danger. Appears when measuring or sourcing high voltages.