User Manual

Operating manual for the GT-400 appliance tester
BEHA-AMPROBE
4
2. Introduction
You have acquired a high-grade device from the company
BEHE-AMPROBE with which you can carry out repeatable
measurements over a very long period of time.
The product was calibrated during the manufacturing process in
accordance with the specified operating procedures.
The GT-400 appliance tester, hereafter referred to as the tester,
has been developed for carrying out the following
measurements for testing the safety of electrical appliances in
accordance with DIN VDE 0701-0702 (BGV A3):
- Measuring the protective conductor resistance
- Measuring the insulation resistance
- Measuring the substitute leakage current
- Testing of IEC and extension cables
Scope of delivery
1 qty GT-400 appliance tester
1 qty set of measuring accessories with safety test line, safety
crocodile clip and safety test tip
6 qty batteries of type AA (Mignon)
1 qty IEC connection cable, 0.5 m
1 qty carrying bag
1 qty operating manual
Transport and storage
Please retain the original packaging for dispatch at a later date,
e.g. for calibration.
Transport damage that occurs due to inadequate packaging is not
covered by the manufacturer’s guarantee.
The appliance tester must be stored in a dry, closed room. If the
device is transported in extreme temperatures, it requires at least
2 hours acclimatisation before being switched on.