Specifications

Air Rie Owner’s Manual
Overll
Overlling beyond the recommended ll pressure does not improve performance, it will actually
lessen the performance and may cause the valve to lock. If you overll the air rie, try ring the
air rie without a pellet until you reach the recommended pressure (2000 psi) or less if that’s
your personal tune preference.
If the air rie will not discharge air, the valve might be pressure locked and will require the use
of the degassing tool that’s included. Follow the instructions below for degassing procedure.
Make sure the air rie is not cocked and unloaded.
Put it on safety mode and pointed in a safe direction with the bolt closed.
Insert the degassing tool as shown in the picture.
Start screwing the tool by rotating clockwise until there is resistance, at this point it will require
more force, it might take 1-2 full turns to degas the air rie.
Remove the tool from the air rie, if left in it will interfere with normal operation.
Cock the air rie and dry re it to make certain there is no pressure left inside, also check the
gauge to assure the pressure has been relieved.
WARNING: DO NOT ATTEMPT TO REPAIR THE AIRGUN OR TO DISASSEMBLE
TO CORRECT AN OVER FILL OR VALVE LOCK. PARTS CAN FLY FROM THE AIRGUN
AT DANGEROUS SPEEDS WHEN IT IS DISASSEMBLED WHILE PRESSURIZED.