Instruction Manual

COCKING & LOADING

1. Point your air pistol in a safe direction. Keeping your ngers

away from the trigger, release the barrel assembly by pulling

down on the hammer with your thumb (Fig 1A). At the same

time lift up on the barrel assembly with your other hand (Fig

1B), extending it to its maximum.

2. Insert a single pellet into the breech end of the barrel as far

as it will go (Fig. 2).

3. Close the air pistol by using your free hand to push down on

the barrel assembly until it engages with the catch (Fig. 3A).

CAUTION: KEEP YOUR FINGERS AWAY FROM THE

BOTTOM OF THE BARREL ASSEMBLY WHEN CLOSING!

(Fig. 3B).

4. The P1 or P11 safety is manual and located near the

triggerguard (Fig. 4). The P3 has an automatic safety located

above the trigger blade (Fig. 5).

FIG. 1A

WARNING:

BE SURE THE AIRGUN IS ALWAYS POINTED IN A SAFE

DIRECTION. NEVER POINT THE AIRGUN AT ANYONE

EVEN IF IT IS UNLOADED. ALWAYS ASSUME AND HANDLE THE AIRGUN AS IF IT WERE

LOADED AND READY TO FIRE.

WARNING:

DO NOT INHALE DUST FROM LEAD PROJECTILES OR

PUT THEM IN YOUR MOUTH. WASH HANDS AFTER

HANDLING LEAD. SOME PELLETS MAY CONTAIN LEAD, A CHEMICLE KNOWN TO THE

STATE OF CALIFORNIA, TO CAUSE CANCER AND BIRTH DEFECTS (OR OTHER

REPRODUCTIVE HARM).

FIG. 2

FIG. 3A

FIG. 1B

P1 OR P11P3

SAFETY "OFF"

FIG. 5

FIG. 4

SAFETY "ON"

FIG. 3B

CAUTION: PINCH POINT