Operation Manual

21
EN Tea Joy Express
BEEM - Elements of Lifestyle
Operation
Switching on the appliance
NOTE
Make sure that the temperature se- ►
lection switch (2) is turned clockwise
to the "O" position until it stops.
Place the kettle onto the cordless so- 
cket (1).
Insert the plug into the mains socket. 
The power indicator light (11) indi-
cates that the appliance is ready for
operation.
Switch on the appliance by turning the 
temperature selection switch (2) clock-
wise to the desired position.
Setting the temperature
The temperature selection switch (2) ena-
bles stepless setting of the water tempe-
rature. You have the choice between the
following settings: warm, hot and boil.
Warm/hot/boil
If you move the temperature selection
switch (2) to the "●", "●●"” or "●●●" positi-
on, the water is heated to the correspon-
ding temperature.
The heating indicator light (12) is switched
on and indicates that the appliance is
heating. After reaching the temperature,
the thermostat switches off the heating
and the heating indicator light (12) extin-
guishes. If the temperature of the water
sinks, the thermostat switches on the hea-
ting again.
Continuous boiling
Fill the kettle (3) with the desired 
amount of fresh water.
NOTE
Observe the lling level indica- ►
tor (10). Do not ll up over the MAX
mark and not under the MIN mark
(refer to illustration A1).
Place the lid (13) onto the kettle (3). 
Place the kettle (3) onto the cordless 
socket (1).
Insert the plug into the mains socket. 
Turn the temperature selection switch 
(2) clockwise to the "
" heating
function to boil the water.
NOTE
With this setting, the thermostat does ►
not switch the heating off and the
water continues to boil.
Switching off the appliance
To switch the appliance off, proceed as
follows:
Turn the temperature selection switch 
(2) clockwise until it stops at the "O"
position.
NOTE
The power indicator light (11) re- ►
mains lighted.
Pull the plug out of the mains socket 
if the appliance is not used for prolon-
ged periods.