Operation Manual
20
Power Station Pro4 EN
BEEM - Elements of Lifestyle
Operation
Filling the water tank
Press the button upwards to release
the lock on the water tank and pull the
tank to the front and out of the appli-
ance (see gure A1).
Remove the calcium lter by pulling it
upwards out of the water lling ope-
ning (see gure A2).
Fill the water tank up to the MAX mark
with approx. 1 litre of water (see gure
A3).
Insert the calcium lter back into the
water tank (see gure C3).
Push the water tank back into the
appliance until it audibly locks in (see
gure A5).
NOTE
During ironing, the pumping noise ►
of the appliance becomes very loud
if the water level is low or the water
tank is empty. In this case, rell the
the tank with water immediately.
It is only possible to remove the tank ►
when the appliance is switched on.
Quickly ll the tank with water and
insert it again.
The water tank light extinguishes if ►
you remove the tank and lights up
again after you have reinserted it.
The light of the water tank only lights ►
up when the tank is inserted and
locked in properly.
Appliance description
(refer to the left fold-out page for illustration)
Water tank1
Carrying handle2
Ironing sole3
Temperature selection button4
Steam button5
Steam button lock mechanism6
Steam button7
Power indicator8
Temperature display 19
Temperature display 210
Temperature display 311
Temperature display 412
Cable/steam hose13
Mains cable14
Carrying handle lock release15
Water tank lock release16
Filter17
Water tank light18
User manual (not illustrated)19
Special functions of the appliance
The appliance is equipped with an ■
electronic temperature setting that
maintains or quickly heats up to the
selected temperature.
The appliance is equipped with an ■
automatic switch-off that switches off
after 20 minutes when the steam iro-
ning function is not in use.
The ■ anti-liming system lter reduces
calcium deposits within the appliance
if normal tap water is used instead of
distilled water (see section Filling the
water tank).