Operation Manual

22
Leopard G5 EN
BEEM - Elements of Lifestyle
Operation and use
Notes
Using as mincer
If you wish to make very ne mince, ■
you can feed the meat through several
times (initially use a perforated disc
with large holes and then one with
smaller holes).
You can chop the ingredients (e. g., ■
onions) together with the mince.
Inedible parts such as bones, gristle ■
or tendons must be removed before
mincing.
Dice the meat rst so that it ts into the ■
feed shaft.
Making sausages
Soak the sausage skin in lukewarm ■
water for 10 minutes. Push the wet
sausage skin over the sausage lling
shaft. Sausage skins can be obtained
at the butchers.
Season the mince and put it into the ■
funnel.
If the sausage skin is sticky, dampen it ■
again with a little lukewarm water.
Numerous recipes are available in the ■
Internet. For example, it is possible to
individually season each one with dif-
ferent spices until the desired avour
has been found.
Using the Kebbe attachment
Kebbe (Kibbeh Mischwiye) is lled meat
rolls. A hollow roll is made with the Kebbe
attachment that can be cut to the desired
length and lled with various different in-
gredients (e. g., meat, vegetables). The
Kebbe portions are subsequently fried.
Switching the appliance on/off
Move switch B (8) followed by switch 
A (7) to the "ON" position to switch on
the appliance.
Move switch A (7) to position "0" (mid- 
dle position) to switch off the appli-
ance.
Using the appliance
Assemble the attachment as de- 
scribed in the section Assembling
the attachment (page 20).
Insert the plug into the mains socket. 
Switch on the appliance as described 
in the section Switching the appli-
ance on/off (page 22).
Put a suitable container under the 
outlet.
Cut the ingredients into pieces to t 
into the feed shaft.
Add the ingredients into the feed shaft 
Press the ingredients downwards us- 
ing the pusher (2) until the feed shaft
is empty.
Eliminating blockages
Switch off the appliance as described 
in the section Switching the appli-
ance on/off (page 22).
Move switch B (8) to position "R". 
Move switch A (7) to position "R" and 
hold down for max. 10 seconds. When
you release the button, it springs back
to position "0".
Pull the plug out of the mains socket. 