Operation Manual

20
Leopard G5 EN
BEEM - Elements of Lifestyle
Appliance description
(See illustration on the left fold-out page)
Lid, pusher1
Pusher2
Tray3
Release button4
Handle5
Motor unit6
Switch A7
Switch B8
Fixture9
feed shaft10
Attachment11
Drive pinion12
Screw conveyer13
Mincing knives14
Perforated disc15
15a Small perforated disc (Ø 3 mm)
15b Medium perforated disc (Ø 5 mm)
15c Large perforated disc (Ø 7 mm)
Locking ring16
Pusher for shortbread biscuits17
Shortbread biscuit attachment18
Sausage lling disc19
Kebbe attachment20
Kebbe shaper21
Sausage lling shaft 122
Sausage lling shaft 223
User manual (not illustrated)24
Switch positions
Switch A (7) and switch B (8) at "ON" ■
position: normal operation
Switch A (7) at "0" position: appliance ■
switched off
Switch A (7) and switch B (8) at "R" ■
position: reverse operation
Overload protections
The motor is protected against overload-
ing by a thermal circuit breaker. It stops
automatically in the event of overloading.
In this case, switch off the appliance and
allow it to cool for approx. 60 minutes.
CAUTION
Observe the maximum operating ►
time of 10 minutes.
Allow the appliance to cool down ►
afterwards for 30 minutes before it is
switched on again.
Preparations
Preassembly
Using as mincer (image A)
Insert the screw conveyer (13) into the 
attachment (11).
Insert the mincing knife (14) with 
the blades facing outwards into the
square of the conveyer screw.
Put the desired perforated disc (15a, 
15b, 15c) onto the screw. The notch in
the perforated disc must lie over the
keyway of the attachment (image E).
Screw on the locking ring (16). 
Making sausages (image B)
Insert the screw conveyer (13) into the 
attachment (11).
Put the sausage lling disc (19) onto 
the screw. The notch in the sausage
lling disc must lie over the keyway of
the attachment.
Insert the desired sausage lling shaft 
(21, 22) through the locking ring (16).
Screw on the locking ring (16). 