Operation Manual

BEEM – Elements of Lifestyle
24 / 72
41. Use only the supplied glass coffee pot without any damage. Use it carefully, it
is very fragile, and do not cool the hot glass coffee pot down with cold water.
42. Do not operate the appliance near explosive or inflammable fumes.
RISK OF INJURY
43.
Remove the bread carefully after toasting.
44.
Transport the appliance only when it is cold and empty.
45. Use only the accessories supplied. Using other parts may lead to personal
injury or damage to property.
WARNING about injuries with other causes
46.
Do not let the power cord hang over corners (trip-wire effect).
CAUTION - damage to property
47. Put the appliance on a flat, heat-resistant, stable surface at least 5 cm from
the wall.
48.
Do not put the appliance on top of other appliances.
49. Never cover the appliance because this will prevent the heat escaping.
50.
Do not use the kettle (11) or the coffee maker without water.
51. If the glass pot (18) is not on the hot plate (17) or is empty, put the switch on
the electric base station (13) to “0”.
52. The kettle (11) may be used only with the electric base station (13) belonging
to it.
53. Furniture today is coated with many types of paints and plastics and is treated
with many different kinds of care products. It can therefore not be entirely
excluded that some of these materials contain components which corrode and
soften the rubber feet. If necessary, place a mat under the feet of the
appliance.
WARNING: No liability can be assumed for any damage in the case of misuse or
incorrect operation.
5 Before initial operation
Make sure that all packaging material has been removed from the appliance
(protective film etc.).
Check that all parts are there (see chapter 3 Description of appliance and scope of
delivery).
Leave the specification plate and any warning notices on the appliance.
CAUTION: Make sure that the appliance is not damaged. If parts are damaged,
do not operate the appliance. Instead, contact qualified service personnel.
Put the appliance on a heat-resistant, dry and flat surface.
Check to see if the crumb tray (1) is in place properly.
Clean the kettle (11) before using it for the first time.
Clean the glass pot (18) with washing-up liquid.
Insert the mains plug in a power socket.
NOTE: When using the appliance for the first time there may be odours arising
from production residues (e.g. fats), this is completely normal. Make sure that
there is sufficient ventilation.
Proceed as follows to prepare the appliance for use:
Long slot toaster
Operate the toaster twice on full power without bread.
Then let it cool down.