Operation Manual

27
EN DYNAMIC i-POWER
BEEM - Elements of Lifestyle
Fill the water tank (12) up to about 
a half with water as described in the
Filling with water section. It is rec-
ommended only to use distilled water
for self-cleaning.
Insert the plug of the appliance into 
the mains socket. The control indica-
tor (11) light ups.
Turn the temperature regulator (13) to 
the "MAX" position.
The temperature indicators (9) light up
on both sides of the appliance during
heat-up.
Wait until the appliance has heated 
up, the control indicator (11) ashes
and the temperature indicators extin-
guish.
Set the temperature regulator (13) to 
the "OFF" position.
Pull the plug out of the mains socket. 
Hold the appliance horizontally over a 
wash basin or similar.
Press the self-clean button (15). 
Allow the the water tank to empty 
completely. Lightly tilt the appliance
back and forth so that the water can
run out of all nozzles.
Repeat the cleaning procedure as 
often as necessary until no calcium
deposits come out of the nozzles.
If necessary, briey switch on the ap- 
pliance to allow residual amounts of
water to evaporate.
NOTE
It is not necessary to decalcify the ►
appliance separately.
Technical data
Model
Steam iron
DYNAMIC i-POWER
Type number
Red-metallic D4,001
Violet-metallic D4,002
Green-metallic D4.003
Dimensions (W x
H x D)
310 x 135 x 155 mm
Approx net weight. 1.4 kg
Operating voltage 220-240 V~
Mains frequency 50/60 Hz
Power
consumption
2800 W
Protection class I
Type of protection IP X0
Water tank
capacity
0.35 litre