Operation Manual

25
EN DYNAMIC i-POWER
BEEM - Elements of Lifestyle
Upright steam ironing
NOTE
Upright steam ironing is suitable for ►
hanging textiles (coats, suits, cur-
tains) and for removing creases.
Only hang the washing to be ironed ►
where heat and humidity cannot
cause damage, NOT in front of
wallpaper, windows or mirrors for
example.
The appliance produces turbo steam ►
for upright steam ironing. This has a
separate pipe and is only discharged
from the front part of the ironing sole.
If necessary, ll the appliance with wa- 
ter (Filling with water section).
During heating up, make sure that 
the appliance is placed upright on an
even surface.
Insert the plug of the appliance into 
the mains socket. The control indica-
tor (11) light ups.
Turn the temperature regulator (13) to 
the "MAX" position.
The temperature indicators (9) light up
on both sides of the appliance during
heat-up.
Hold the appliance upright with a gap 
of 5 to 15 cm in front of the fabric to
be ironed and press the steam shot
button (4) every 2 to 5 seconds. .
Move the ironing sole up and down in
front of the fabric.
If steam is no longer discharged, wait 
for a few seconds until the appliance
produces new steam.
Steam shot
NOTE
The lower the temperature set, the ►
less steam is discharged from the
appliance and the longer the inter-
vals until steam is generated again.
Press the steam shot button (4) to dis- 
charge a steam shot. . Press the
button at intervals of a few seconds.
Spray function
NOTE
The spraying function is ideally suit- ►
ed for moistening stubborn creases
in cotton or linen.
Press the button (5)  so that the
appliance discharges a spray shot.