Operation Manual

35
EN Café Joy V2
BEEM - Elements of Lifestyle
Installing the strainer insert
NOTE
Select the at strainer insert (13a) to ►
make a cup of espresso (image B1).
Select the deep strainer insert (13b) ►
to make two cups of espresso at the
same time or for a double espresso.
Turn the nib on the side of the strainer 
insert (13) towards the handle (11)
and insert the strainer (12) into the
holder (image B 2).
After inserting, turn the strainer (13) 
a quarter-turn to the left or right. The
nib prevents the strainer insert from
falling out.
Removing the strainer insert
After using, empty the strainer insert 
(13) as described in the section Emp-
tying/cleaning the strainer insert
(page 40).
Turn the strainer insert (13) so that 
the nib on the wall of the strainer
insert is pointing towards the handle
and lift the strainer insert (13) out of
the holder (12).
Installing the strainer holder
NOTE
The following symbols refer to ►
the mark (6) on the brewing unit
.
Hold the strainer holder (12) using the 
handle (11) under the symbol on the
brewing unit (6) and push the strained
holder into the brewing unit from be-
low (image D1).
NOTE
Take care not to tilt the strainer ►
holder.
Turn the handle (11) of the strainer 
holder (7) to the right until the handle
is under the symbol (image D2).
Removing the strainer holder
Turn the handle (11) of the strainer 
holder (12) to the left until the handle
is under the symbol on the brewing
unit.
Take the strainer holder out of the 
strainer holder from below.