Operation Manual

25
EN Bi-Turbo Accustar
BEEM - Elements of Lifestyle
Troubleshooting
The following table will help you locate and eliminate minor faults:
Fault Possible cause Remedy
The charging control
indicator (4) of the hand
vacuum cleaner does not
light up after it is put onto
the charging station.
Charging station power
adapter not plugged in.
Insert plug.
Automatic circuit breaker in
electrical distribution board
tripped.
Switch on the automatic
circuit breaker again.
Hand vacuum cleaner was not
put into the charging station
correctly.
Put the hand vacuum
cleaner correctly into the
charging station.
The automatic circuit
breaker in the electrical
distribution board trips.
Too many appliances connect-
ed to the same power circuit.
Reduce the number of
appliances on the power
circuit.
No fault detected.
Contact customer
service.
The appliance does not
function after pressing the
ON/OFF switch.
Battery not charged Charge battery
Vacuum performance is
inadequate.
Battery not fully charged. Charge battery
Dust container (8) full up Empty dust container (8)
Dust container (8) not cor-
rectly inserted.
Insert dust container (8)
correctly
Filter (6) is clogged.
Replace lter (6) as
described in the section
Replacing the lter
(page 23).
Turbo brush does not work
Dust container (8) or turbo
brush not properly attached.
Attach dust container
and turbo brush prop-
erly, the contacts must
touch each other.
NOTE!
If you cannot resolve the problem with the steps described above, please contact ►
customer service.