Operation Manual

23
EN Bi-Turbo Accustar
BEEM - Elements of Lifestyle
Cleaning and care
Before beginning work, pay attention to
the safety instructions in the Safety sec-
tion (page 17)!
Cleaning the appliance
Pull the power adapter of the charging 
station out of the mains socket,
Use a slightly moist cloth to wipe 
off the housing of the hand vacuum
cleaner, the charging station and the
accessory parts.
Cleaning the dust container
Check the dust container (8) after empty-
ing each time, however at least every 3 to
6 months. If you detect dirt, clean the dust
container as follows:
Switch off the appliance. 
Press the unlocking button (4), hold it 
down and pull the dust container off
the hand vacuum cleaner.
Empty the dust container (8). 
If necessary, replace the lter (6) as 
described in the section Replacing
the lter (page 23).
Rinse the dust container with water 
and clean it with a slightly damp cloth.
Dry off the dust container. 
Push the dust container back onto the 
motor unit (5) until it engages.
Replacing the lter
The lter removes very ne particles
before the air is blown out (5) of the appli-
ance.
Check the lter (6) every 3 to 6 months. If
dirt is detected during checking, replace
the lter.
Proceed as follows:
Remove the dust container(8) from 
the appliance.
Remove the lter unit (6/7) from the 
dust container.
Remove the lter (6) from the lter 
housing (7).
Insert the lter (6) into the lter hous- 
ing (7).
Insert the lter unit (6;7) back into the 
dust container.
Push the dust container (8) back into 
the motor unit (5) until it engages.