Installation manual

Setting Up the System Shutting Down the System
24 Apr 2004
6
6.2 Shutting Down the System
Press and hold either power buttons for a few seconds,
while the handset display shows the message shown below.
Let go of the button when the display shows the message
below, and the green LED on the front of the terminal starts
flashing.
Note: Wait at least 10 seconds after a shut down, before
trying to power up the F33 system again.
6.3 Service User Menu
Before the system is ready to make the first call – some
basic system configuration is necessary. The Service User is
the only user having access to all functionality in the
system. The Service User must therefore perform all
changes to the configuration.
The system configuration can be accessed via the handset
or by running the FleetCp program from a PC connected to
the transceiver (cf. User Manual section 5.1 “System Set-
up from PC”).
All configuration information is stored in the configuration
module. It takes approx. 10 sec for the system to update

Powering
Down

Thrane F33
Goodbye