User Manual

ManualsBrandsBeefeater ManualsAll BBQ / BarbequesSignature ProLine™ 6 Burner Built-In Natural Gas BBQ with Hood

UNIVERSAL LPG AND PROPANE INSTALLATION

NOTE: Conversion of this unit to Universal LPG or Propane

must be carried out by a qualified licensed person and a

Certificate of Compliance must be issued to the owner on

completion of the installation and conversion� Conversion of

the barbecue by unlicenced persons may result in improper

functioning of the appliance, injury, property damage and

may affect your ability to make a claim under under the

manafacturer’s warranty�

Converting the unit to Universal LPG or Propane gas

This barbecue is set up for Natural gas and is labelled

accordingly� A Universal LPG and Propane conversion Kit is

supplied with the product�

The components in the kit are:

• Brass adaptor

• Sealing washer

• Small plastic bag containing:

– 6 x 0�9 brass injectors (Universal LPG)

• Small plastic bag containing:

– 6 x 0�95 brass injectors (Propane)

• Universal LPG sticker

• Propane sticker

1. Replace ‘gas type’ sticker

• Locate ‘Natural gas’ sticker located on the barbecue

gas inlet and remove it� Put either the Universal LPG or

propane sticker in it’s place�

2. Change the injectors

• Remove spark electrode and thermocouple from the

burner�

• Release the burner from the retaining bracket by lifting

as shown�

• Unscrew Natural gas injectors and replace with

either Universal LPG or Propane injectors�

Universal LPG injectors have 0�90mm diameter

orifice� Propane Gas injectors have 0�95mm diameter

orifice� All injectors are marked with the orifice size�

• Install burner and re-attach the spark electrode and

thermocouple�

• Repeat for the other 5 burners

NOTE: The final step in the conversion of the barbecue to

either Universal LPG or Propane is the adjustment of the

turndown setting�

This can only be completed after the barbecue has been

connected to a supply of gas� Refer to ‘Connection to Universal

LPG and Propane Gas Supply’ detailed in next section�

3. Adjust the turndown setting on the valve

• Light each burner and rotate the control knob to the

lowest setting, then remove the knob from the valve

shaft, and remove the grommet�

• Using a small flat-blade screwdriver adjust the

turndown adjustment screw to achieve a small steady

flame on the burner�

Turndown screw

• Replace the knob

• Recheck the operation of the burner at maximum and

turndown

• Repeat procedures for all valves�

Remove 1�75mm injector

and install 0�90mm injector

for Universal LPG gas or

0�95mm for Propane gas�

Remove burner to

access injector