User Manual

20 GAS SPECIFICATIONS
GAS SPECIFICATIONS
Gas leak test procedure
Use the following procedure to check for gas leaks.
Never use a naked flame to check for gas leaks.
FIG 1
Standard POL regulator (AU/NZ regulator)
FIG 2
Quick connect regulator (North America regulator)
1. In a small container, mix up a solution of water and
detergent or soap. Mix the solution well.
2. For LPG make sure that the gas supply valve on the gas
cylinder is turned on. For Natural gas make sure that
the gas line is correctly fitted to the appliance.
3. Make sure that the gas control valves on the appliance
are all turned off.
4. Using a brush or spray bottle apply the solution to the
gas line and each join in the gas line. See Fig 3.
5. Bubbling of the solution will indicate that there is a
leak present.
6. Re-tighten or re-seal any joints that are leaking.
7. If a leak persists then contact your distributor or the
manufacturer for assistance.
FIG 3
Gas shutoff valve
Gas shutoff valve
Bleeder valve screw
Bleeder valve screw
Protector cap
Protector cap
Gas cylinder
Gas cylinder
Regulator and hose
Regulator and hose
Tighten in this direction
Tighten in this direction