Installation Manual

Procedure
BedTred Truck Bed Liner Installation Instructions
5. Zip the BedTred truck bed panels together
From the back (loop side) of the panels, zip
the two side panels to the Floor Panel (starting
at the back of the BedTred) and then zip the
Bulkhead Panel to the Floor Panel.
6. Place the joined BedTred panels in truck
Turn the BedTred over again and place it
carefully into the truck bed.
Position the Floor Panel carefully.
8. Some Truck beds are equipped with tie-
down hooks- load extenders and other
equipment on the floor, bulkhead or
sidewalls. For these you must either:
a. Cut a small slit in the appropriate area,
allowing the equipment to protrude through
the BedTred surface (this will not damage
the BedTred) or,
If you removed the above equipment as
noted in Step 2, install the BedTred and then
reinstall the equipment over the BedTred
surface.
Note: An awl works well to locate and
punch holes.
7. Attach Bulkhead Panel to Truck Bed.
Wipe all contact areas with alcohol, then let
dry.
Remove backing tape and attach lower
fasteners first. Work from the bottom up and
the center out.
IMPORTANT: Do not remove backing tape
until ready to adhere tape to truck bed.
Press all fasteners firmly in place.
b.
ULTRA
UTINST Rev. 1 7/27/2016
Page 3 of 6