Installation Manual

Bed Liner Installation Instructions

Procedure

GBRINST Rev. 1 7/14/2017 Page 6 of 6

NOTE: If using the bed liner in conjunction with a

bed extender, cut the slits (located on back of part)

of the D-pillar area to allow access to attachment

holes. (Fig 8-2) The size and number of slits will

vary depending on the application

Installing Bed Liner tailgate

FOR 05+ TACOMA MODELS:

Remove screws from the tailgate cap. DO NOT

REMOVE THE CAP.

Slide the top of the bed liner tailgate section

underneath the cap and align the holes with the screw

holes.

Reinstall the screws using the spacers as shown

(Fig. 9-1)

Install hook fasteners on bottom edge of tailgate,

remove the film, then proceed to step (e) below.

FOR ALL OTHER MODELS:

(a) Rotate the bed liner up to access tailgate fasteners.

(b) Clean attachment areas thoroughly with alcohol and

allow to dry.

(d) Remove the film and align the edge of the bed liner

tailgate section to the top edge of the tailgate.

(Fig 9-2)

Do not adhere the hook fastener to the factory

plastic tailgate cap unless a 4298 adhesive

promoter pack is included in the hardware kit.

Most models are designed to adhere to sheet metal

just below plastic tailgate cap.

(e) Roll the bed liner tailgate back in place.

(f) Firmly press the bed liner tailgate for 15 seconds to

ensure adhesive attachment.

(g) After installation is complete, tuck bed liner material

between the tailgate and truck bed.

Fig. 9-2

Utility Knife

. 8-2

Fig. 9-1