Installation Manual

Bed Liner Installation Instructions
Procedure
GBRINST Rev. 1 7/14/2017 Page 5 of 6
7. Fitting Bed Liner for beds with tie-down
hooks or other optional features
Some truck beds are equipped with tie-down hooks,
load extenders, accessory lights and other
functional equipment located in the floor or
sidewalls. For these the installer must either:
(a) Cut a small slit or opening in the appropriate area
allowing the equipment to protrude through the bed
liner surface (This will not damage the bed liner) or,
(b) Remove the equipment until the bed liner installation is
complete, then reinstall the equipment on top of the
bed liner.
-OR-
Do not cut through any seams or sewn lines.
TIP: It is easiest to locate fastener holes with an awl
after bed liner is positioned for best fit.
Be sure to re-torque tie down fasteners to the OEM
8.
Installing Bed Liner sidewalls
(a) Rear vertical edge of bed liner should be positioned to
match D-pillar surface. Start at front and working
rearward begin removing film from fasteners bottom
to top and from front to back. Firmly press the bed
liner sidewall for 15 seconds to ensure adhesive
attachment. Repeat for other side. (Fig 8-1)
Fig. 7a
Fig. 7
b
Fig. 8-1
07+ GM Shown
15+ F150 Shown