Installation Manual

Bed Liner Installation Instructions

Procedure

GBRINST Rev. 1 7/14/2017 Page 4 of 6

6. Installing Bed Liner floor and bulkhead

(a) Locate bed liner in the truck bed.

(b) Position the bed liner - front to rear and left to right by

aligning all edges and tucking corners into place. (Fig

6-1)

fastener located on the bed liner bottom.

(d) Clean attachment area thoroughly with alcohol and

allow to dry.

(e) Remove the film. (Fig 6-2)

(f) Roll the bed liner floor and sidewalls back in place.

(g) Firmly press the bed liner top surface for 15 seconds

to ensure adhesive attachment.

(h) Repeat for other side

(i) Fit top edge of bed liner bulkhead to top edge of body

panel to determine best location. (Fig 6-3)

Be sure fasteners are located on a flat solid surface of

truck bed.

(j) Clean attachment areas thoroughly with alcohol and

allow to dry.

(k) Remove the film working from bottom to top and

center of part outboard.

(l) Roll the bed liner top edge back in place.

(m) Firmly press the bed liner top surface for 15 seconds

to ensure adhesive attachment.

Fig. 6-2

Fig. 6-1

Fig. 6-3