Installation Manual

Bed Liner Installation Instructions
Procedure
GBRINST Rev. 1 7/14/2017 Page 3 of 6
5. Installing fasteners to Bed Liner.
(a) Attach (2) 1”X 36”, 1”X 2” and 1”X 60” hook to
underside of the bed liner and tailgate. Trim 1”X 60”
strip where necessary. Do not remove adhesive
protective film at this time. (Fig 5-1)
(b) Attach 1” X 60” and 1” X 2” hook to the bed liner
bulkhead area facing the front as shown. Trim excess
from 1” X 60” strip where necessary. Do not remove
adhesive protective film at this time. (Fig. 5-2)
Middle 1” x 2” row of hook fasteners shown are not
applicable on some models.
(b) Attach 1” X 2” fasteners to the back sides of the bed
liner sidewalls as marked by locators. Do not remove
adhesive protective film at this time. (Fig 5-3)
Fig. 5-1
Fig. 5-2
Fig. 5-3