Installation Instructions

Girard, PA 16417
www.emscogroup.com
3 EASY STEPS
Create curves, corners and straight runs by simply tapping spikes through
interlocking pieces to secure. Interlocking sections make continuous lengths.
Continue fencing run.
As you go, t Bedrocks TrimFree Border pieces together with convenient
interlocking system. If the stepped part of Bedrocks is on the bottom
when you reach the end of your run, use the female end cap to nish.
If the stepped part is on the top, use
the male end cap to nish the run.
See large illustration above.
3
Lay out border pieces along the area where you want to install.
Be sure the border pieces are touching. You may want to overlap them
as you proceed. For best results, mow lawn before installation.
See illustrations below for installation tips.
1
Push pointed spikes through
border and into ground. If ground
is too hard, soften it with water. If necessary,
make starter holes with screwdriver.
2
To finish your landscape border,
where the stepped part of
Bedrocks is on the top of the
run, use the male end cap.
Place cap on the main edging
piece (as shown) and tap a
long spike through both pieces.
Use the long spikes for
the stacked-slate portion
of Bedrocks™
Use the short spikes for the flanged or
flat-slate portion of Bedrocks™
Male end cap
is small piece with
slate on top and side
surfaces.
To achieve the
maximum corner
angle (with the
turn going toward
the flange) you
will need to cut a
small piece out of
the Bedrocks wall
(see illustration).
For best results use a hack saw.
To finish your landscape
border, where the stepped
part of Bedrocks is on the bottom
of the run, use the female end cap.
Place cap under the main edging piece
(as shown) and tap a long spike through both pieces.
Female end cap is small piece with slate on side surface only.