User Manual

Gearshift light
Switching gearshift light
on and off
Go to the Settings,
Vehicle settings menu.
Switch Shift light on or off.
Setting upshift indicator
Switch on the Shift light
function.
Go to the Settings,
Vehicle settings,
Configuration menu (under
Shift light).
The following settings are avail-
able:
Start speed
End speed
Brightness
Frequency. A flashing fre-
quency of 0 Hz corresponds to
steady light.
Changes to brightness and the
flashing frequency are demon-
strated by the shift light with it
briefly lighting up or flashing.
Anti-theft alarm (DWA)
with anti-theft alarm (DWA)
OE
Activation
Switching on ignition ( 60).
Customising anti-theft alarm
settings ( 77).
Switch off the ignition.
If the alarm system is activated,
then the alarm system will be
automatically activated when
the ignition is switched off.
Activation takes approximately
30 seconds to complete.
Turn indicators flash twice.
Confirmation tone sounds
twice (if programmed).
Anti-theft alarm is active.
Alarm signal
A DWA alarm can be triggered
by:
motion sensor
switch-on attempt with an un-
authorised vehicle key
disconnection of the DWA anti-
theft alarm from the motor-
cycle's battery (DWA internal
battery in the anti-theft alarm
provides power - alarm tone
only, the turn indicators do not
flash)
All functions are sustained even
if the internal battery of the DWA
anti-theft alarm system is flat; the
only difference is that an alarm
cannot be triggered if the system
4
76
z Operation