User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Battery for tyre pressure
sensor weak
with tyre pressure control
(RDC)
OE
General warning light shows
yellow.
RDC sensor battery
weak. Function lim-
ited. Have it checked by a
specialist workshop.
NOTICE
This error message shows briefly
only after the Pre-Ride-Check
completes.
Possible cause:
The tyre pressure sensor battery
no longer provides its full capa-
city. The tyre pressure monitor-
ing function will be available for a
limit time only.
Seek the advice of a specialist
workshop, preferably an author-
ised BMW Motorrad Retailer.
Drop sensor defective
General warning light shows
yellow.
Drop sensor faulty.
Have it checked by a
specialist workshop.
Possible cause:
The drop sensor is not available.
Seek the advice of a specialist
workshop, preferably an author-
ised BMW Motorrad Retailer.
Motorcycle dropped
Engine start not pos-
sible. Straighten
up motorbike. Switch ig-
nition off/on. Start en-
gine.
Possible cause:
The drop sensor has detected a
drop and has cut out the engine.
Bring the motorcycle to the
upright position.
Switch the ignition off and
then on again or switch the kill
switch on and then off again.
Emergency call function
restricted
with intelligent emergency
call
OE
Intell. emerg. call
failure.
Possible cause:
The emergency call cannot be
cannot be made automatically or
via BMW.
Observe the information on
operating the intelligent emer-
gency call from page ( 62)
onwards.
3
50
z
Status indicators