User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Exercise restraint when using
a steam jet or high pressure
cleaning equipment.
Cleaning easily
damaged components
Plastics
ATTENTION
Use of unsuitable cleaning
agents
Damage to plastic surfaces
Do not use cleaning agents
that contain alcohol, solvents or
abrasives.
Do not use insect-remover
pads or cleaning pads with
hard, scouring surfaces.
Body panels
Clean trim panel components
with water and BMW Motorrad
solvent cleaner.
Plastic windscreens and
headlight lenses
Remove dirt and insects with
a soft sponge and generous
amounts of water.
NOTICE
Soften stubborn dirt and insects
by covering the affected areas
with a wet cloth.
Clean with water and
sponge only.
Do not use any chemical
cleaning agents.
Chrome
Carefully clean chrome sections
with a generous amount of water
and motorcycle cleaner from the
care series BMW Motorrad Care
Products. This applies especially
where road salt has been in use.
For an additional treatment, use
BMW Motorrad metal polish.
Radiator
Clean the radiator regularly to
prevent overheating of the en-
gine due to inadequate cooling.
For example, use a garden hose
with low water pressure.
ATTENTION
Bending of radiator fins
Damage to radiator fins
Take care not to bend the radi-
ator fins when cleaning.
Rubber
Treat rubber components with
water or BMW rubber-care
products.
ATTENTION
Application of silicone sprays
to rubber seals
Damage to the rubber seals
12
219
z
Care