User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Beneath the tail-hump
cover
1 Connector for optional ac-
cessories, rear
Connecting optional
accessories and racing
accessories
Requirement
Remove the side panel, rear seat
or tail-hump cover, as applicable,
to gain access to the plugs.
Removing fairing side panel
with engine spoiler ( 197).
with two-up riding package
OE
Removing rear seat ( 80).
Remove tail-hump cover
( 79).
Removing tail-hump trim panel
( 198).
Unlock the protective cap or
terminating resistor, as applic-
able, and disconnect it from the
plug.
Connect the optional accessory
or racing accessory, as applic-
able.
NOTICE
Comply with the installation
instructions supplied with the
optional accessory or racing
accessory.
NOTICE
Tightening the cable ties has to
be the last step in the process;
this is in order to ensure that
the wiring harness can be posi-
tioned correctly and that there is
no strain on the cable legs with
plugs.
ATTENTION
Dirt and damp penetrating
inside open connectors
Malfunctions
Reinstall the cap or terminating
resistor, as applicable, after re-
moving the plug.
After removing the accessory:
Reinstall the cap or terminating
resistor, as applicable.
Installing side panel ( 198).
with two-up riding package
OE
Install the rear seat ( 80).
Installing tail-hump cover
( 80).
Installing tail-hump trim panel
( 200).
11
214
z
Accessories