User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Be sure to read and comply
with the instructions for char-
ging the battery on the follow-
ing pages.
Do not turn the battery upside
down.
ATTENTION
On-board electronics (e.g.
clock) draining connected
battery
Battery is deep-discharged; this
voids the guarantee
Connect a float charger to the
battery if the motorcycle is to
remain out of use for more
than four weeks.
NOTICE
BMW Motorrad has developed a
float charger specially designed
for compatibility with the elec-
tronics of your motorcycle. Us-
ing this charger, you can keep
the battery charged during long
periods of disuse, without having
to disconnect the battery from
the motorcycle's on-board sys-
tems. You can obtain additional
information from your authorised
BMW Motorrad dealer.
Disconnecting battery
from motorcycle
Place the motorcycle on its
stand on firm, even ground.
Removing front seat ( 81).
with anti-theft alarm (DWA)
OE
If applicable, switch off DWA.
ATTENTION
Battery not disconnected in
accordance with correct pro-
cedure
Risk of short-circuit
Always proceed in compliance
with the specified disconnec-
tion sequence.
Remove bolt 1 and wiring har-
ness negative terminal 2, then
push forward.
Remove bolt 3 and wiring har-
ness positive terminal 4.
10
203
z
Maintenance